Fans are one of the most important part of this truck since we are using a small radiator to save space. We needed hi-output with minimal room being used. To solve this equation we got a set of flex-a-lite dual fans (originally made for a Tundra) and modified the trucks front radiator support to accommodate. As you can see its a snug fit but they do work perfectly, we just needed to clean up the area and remove some excess metal to allow maximum air flow to the fans and radiator.
While the engine was removed and before we painted, we marked the area not being used by the core support and hood latch to remove as much material as possible. We didn't want anything restricting out much needed cool air flow or getting in the way of our massive innercooler also being added in the area. Using a simple silver metal marker we marked it out and used a combination of diegrinder and air saw to remove the metal leaving a small lip all the way around. This lip was left on purpose, this way we can roll it around the remaining metal giving a smooth un-jagged finish that won't cause any cuts or issues of fraying later.
We were able to remove a large amount of metal with out effecting anything and we went ahead and removed the old radiator mounts since the were no longer needed just to save weight and clean up the engine bay a little more. We also found a couple rust holes in the support that we went ahead and patched while the area was easily accessible.
The finished result was a perfectly fitting hi-flow minimal room set of fans that will
keep this truck cool and any temperature.
No comments:
Post a Comment